Clipping is the most common way subwoofers get damaged, and it’s almost entirely avoidable. Here’s what it is, how to recognise it and how to set your system so it never happens.
Clipping happens when an amplifier is asked for more than it can deliver. The tops of the waveform get flattened, creating harsh distortion and extra heat in the voice coil. Keep gains sensible, don’t max out volume knobs, and turn down when bass starts to sound strained.
What clipping actually is
An amplifier can only swing its output voltage so far. If the input signal asks for more, the amp “clips” the peaks flat. A clipped bass wave looks more like a square wave, which contains extra high-frequency energy and keeps the voice coil at full power for longer. That’s why clipping both sounds bad and heats the driver.
Two places clipping happens
- Upstream (the source or receiver): a receiver’s sub output driven too hot, or a heavily boosted bass EQ, sends an already-clipped signal to the sub.
- At the sub’s amplifier: gain set too high, or simply asking a small sub for more than it can do.
How to recognise it
- Bass that sounds harsh, flat or “fuzzy” rather than round.
- A sub that seems to stop getting louder as you turn it up.
- Clicking, slapping or popping on big bass hits.
- A protection or limit light on the sub, or the sub cutting out.
How to prevent it
- Set the sub’s gain around the middle and adjust overall level in the receiver. See how loud should a sub be.
- Avoid large bass boosts in EQ; cut peaks instead. See how to EQ.
- Keep the receiver’s sub trim within a few dB of 0 after calibration.
- In car audio, set amplifier gains properly with a test tone and multimeter or oscilloscope, not by ear.
- If you need more bass than your sub can give cleanly, the answer is a bigger sub or a second sub, not more gain. See how many subwoofers.
Is brief clipping dangerous?
An occasional brief clip on a movie explosion is unlikely to damage a well-designed home sub, and many have limiters that prevent it. Sustained clipping at high volume, especially in car audio with powerful amplifiers, is what destroys voice coils. If you hear it, turn down.